Connecting The Mx960 Router To A Network For Out-Of-Band Management; Figure 81: Alarm Relay Contacts; Figure 82: Ethernet Port - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Related
Documentation

Connecting the MX960 Router to a Network for Out-of-Band Management

250
Plug the terminal block into the relay contact, and use a 2.5-mm flat-blade screwdriver
3.
to tighten the screws on the face of the block.
Attach the other end of the wires to the external device.
4.
To attach a reporting device for the other kind of alarm, repeat the procedure.

Figure 81: Alarm Relay Contacts

Tools and Parts Required for MX960 Router Connections on page 247
Replacing Connections to MX960 Routing Engine Interface Ports on page 343
Connecting DPC, MPC, MIC, or PIC Cables to the MX960 Router on page 253
Routing Engine Interface Cable and Wire Specifications for MX Series Routers on
page 142
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet cable with RJ-45 connectors to the
Ethernet cable is provided with the router. To connect to the
Routing Engine:
Turn off the power to the management device.
1.
Plug one end of the Ethernet cable
2.
the port on the Routing Engine.
ETHERNET
Plug the other end of the cable into the network device.
3.

Figure 82: Ethernet Port

port on the Routing Engine. One
ETHERNET
ETHERNET
(Figure 78 on page 248 shows the connector) into
Figure 77 on page 248
Copyright © 2017, Juniper Networks, Inc.
port on the
shows the port.