MX960 3D Universal Edge Router Hardware Guide
Removing the MX960 Craft Interface
Installing the MX960 Craft Interface
308
Figure 111: Alarm Relay Contacts
To remove the craft interface (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Detach any external devices connected to the craft interface.
2.
Loosen the captive screws at the left and right corners of the craft interface faceplate.
3.
Grasp the craft interface faceplate and carefully tilt it toward you until it is horizontal.
4.
Disconnect the ribbon cable from the back of the faceplate by gently pressing on both
5.
sides of the latch with your thumb and forefinger. Remove the craft interface from
the chassis.
Figure 112: Removing the Craft Interface
To install the craft interface (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Grasp the craft interface with one hand, and hold the bottom edge of the craft interface
2.
with the other hand to support its weight.
Figure 112 on page
308):
Figure 90 on page
266):
Copyright © 2017, Juniper Networks, Inc.