Figure 52: Installing The Mounting Hardware For A Four-Post Rack Or Cabinet; Rack - Juniper MX960 Hardware Manual

Related
Documentation
Installing the MX960 Mounting Hardware for Front-Mounting in an Open-Frame Rack
Copyright © 2017, Juniper Networks, Inc.
Figure 52: Installing the Mounting Hardware for a Four-Post Rack or
Cabinet
After the mounting hardware is installed, proceed to
a Mechanical Lift" on page
Installing the MX960 Mounting Hardware for Center-Mounting in an Open-Frame Rack
on page 199
Installing the MX960 Mounting Hardware for Front-Mounting in an Open-Frame Rack
on page 197
MX960 Rack-Mounting Hardware on page 14
Before front-mounting the router in an open-frame rack, install the large mounting shelf
on the rack, and remove the mounting brackets from the chassis. The small mounting
shelf is not needed.
Table 96 on page 198 specifies the holes in which you insert screws to install the mounting
hardware in an open-frame rack (an
distances are relative to one of the standard U divisions on the rack. For reference, the
bottom of all mounting shelves is at 0.04 in. (0.02 U) above a U division.
Chapter 15: Installing the Mounting Hardware
"Installing the MX960 Router Using
214.
indicates a mounting hole location). The hole
X
197