Scbe2 Interoperability With Existing Hardware - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Maximum Power
Requirements
LEDs

SCBE2 Interoperability with Existing Hardware

SCBE2 Operating Mode
Mixed Mode Allowed
(DPC+MPC in a chassis)
Enhanced IP/Enhanced
Ethernet Mode Only
Routing Engines
Related
Documentation
116
SCBE2-MX (applies to MX240, MX480, and MX960)
185 W at 55° C
160 W at 40° C
155 W at 25° C
,
FABRIC ACTIVE FABRIC ONLY
The BITS , GPS , and UTI LEDs, located next to the
respective clocking interface.
The LINK LED located next to the two Ethernet ports, indicate the status of the respective SFP+
interface.
For more information about the SCBE2-MX LEDs, see
MX240/480/960
DPC/MS-DPC
MS-MPC
MPC1/MPC2
MPC3
16x10G MPC
MPC4
MPC2-NG/MPC3-NG
MPC5
MPC6
MPC7 (480G)
MPC8 (960 Gbps)/MPC9 (1.6Tbps)
RE-S-1300(EOLed)
RE-S-2000 (EOLed)
RE-S-1800
RE-S-X6-64G
MX-Series Switch Control Board (SBC) Overview
SCBE2-MX LEDs on page 117
, and LEDs indicate the status of the SCBE2-MX.
OK/FAIL
EXT CLK port, indicate the status of the
"SCBE2-MX LEDs" on page 117.
Supported
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
No
yes
yes
yes
yes
Copyright © 2017, Juniper Networks, Inc.