Mx960 Fan Leds On The Craft Interface; Mx960 Cable Manager Description; Table 11: Scb Leds On The Craft Interface; Table 12: Fan Leds On The Craft Interface - Juniper MX960 Hardware Manual

MX960 Fan LEDs on the Craft Interface

Related
Documentation

MX960 Cable Manager Description

Copyright © 2017, Juniper Networks, Inc.

Table 11: SCB LEDs on the Craft Interface

Label Color
Green
OK
–
Red
FAIL
The fan LEDs are located on the top left of the craft interface.
describes the functions of the fan LEDs.

Table 12: Fan LEDs on the Craft Interface

Label Color
Green
FAN
Red
MX960 Craft Interface Overview on page 15
MX960 Alarm Relay Contacts on the Craft Interface on page 15
The standard cable manager (see
line-card cage, which has a row of fourteen dividers for securing the cables for each Dense
Port Concentrator (DPC), Modular Port Concentrator (MPC), Modular Interface Card
(MIC), or PIC.
You can use cable strips or other ties to gently secure the cables in the standard cable
manager. To secure the cables in place, loop the tie through the cable anchor and secure
the tie. You can pull the standard cable manager up and outward to lock it into the
maintenance position. This allows you to access the lower fan tray and the air filter.
Chapter 3: Chassis Components and Descriptions
State Description
On steadily SCB: Fabric and control board functioning normally.
Blinking SCB is transitioning online or offline.
Off The slot is not online.
On steadily SCB has failed.
State Description
On steadily Fan is functioning normally.
On steadily Fan has failed.
Figure 6 on page 20) is a tray located below the
Table 12 on page 19
19