MX960 3D Universal Edge Router Hardware Guide
Removing the FPCs Before Installing the MX960 Router with a Lift
212
To remove an FPC (see
Figure 61 on page
Have ready an antistatic mat for the FPC. Also have ready rubber safety caps for each
1.
PIC using an optical interface on the PIC that you are removing.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to an approved site ESD grounding point. See the instructions for your site.
Simultaneously turn both the ejector handles counterclockwise to unseat the FPC.
3.
Grasp the handles, and slide the FPC straight out of the card cage halfway.
4.
Place one hand around the front of the FPC and the other hand under it to support it.
5.
Slide the FPC completely out of the chassis, and place it on the antistatic mat or in
the electrostatic bag.
CAUTION:
The weight of the FPC is concentrated in the back end. Be
prepared to accept the full weight—up to 18 lb (8.2 kg)—as you slide the
FPC out of the chassis.
When the FPC is out of the chassis, do not hold it by the ejector handles,
bus bars, or edge connectors. They cannot support its weight.
213):
Copyright © 2017, Juniper Networks, Inc.