Ac Power Cord Specifications For Ex2200 Switches - Juniper EX2200 Hardware Manual

EX2200 and EX2200-C Switches Hardware Guide
Table 35: DC Power Supply Electrical Specifications for EX2200 Switches (continued)
Item
Output holdup time
Related
Documentation

AC Power Cord Specifications for EX2200 Switches

64
NOTE: EX2200 switches with DC power supply do not provide PoE.
NOTE: For DC power supplies, we recommend that you provide at least 3.5 A
at 48 VDC and use a facility circuit breaker rated for 10 A minimum. Doing so
enables you to operate the switch in any configuration without upgrading
the power infrastructure, and allows the switch to function at full capacity
using multiple power supplies.
AC Power Cord Specifications for EX2200 Switches on page 64
Power Supply in EX2200 Switches on page 23
General Safety Guidelines and Warnings on page 211
General Electrical Safety Guidelines and Warnings on page 243
A detachable AC power cord is supplied with the AC power supplies. The coupler is type
C13 as described by International Electrotechnical Commission (IEC) standard 60320.
The plug at the male end of the power cord fits into the power source outlet that is
standard for your geographical location.
CAUTION: The AC power cord provided with each power supply is intended
for use with that power supply only and not for any other use.
NOTE: In North America, AC power cords must not exceed 4.5 meters
(approximately 14.75 feet) in length, to comply with National Electrical Code
(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical
Code (CEC) Section 4-010(3). The cords supplied with the switch are in
compliance.
Table 36 on page 65 gives the AC power cord specifications for the countries and regions
listed in the table.
Specification
1 ms minimum
Copyright © 2016, Juniper Networks, Inc.