Figure 24: Attaching The Mounting Bracket Along The Front Of The Switch - Juniper EX2200 Hardware Manual

Copyright © 2016, Juniper Networks, Inc.
To mount the switch on two posts of a two-post or a four-post rack:
Remove the switch from the shipping carton (see
1.
page 113).
Place the switch on a flat, stable surface.
2.
Align the mounting brackets along the front or rear of the side panels of the switch
3.
chassis depending on how you want to mount the switch. For example, if you want
to front-mount the switch, align the brackets along the front of the chassis.
Figure 24 on page 123 shows attaching the mounting brackets along the front of the
EX2200 switch.

Figure 24: Attaching the Mounting Bracket Along the Front of the Switch

NOTE: The length of the mounting brackets depends on the switch model.
Align the bottom holes in the mounting brackets with holes on the side panels of the
4.
switch chassis.
Insert the mounting screws into the aligned holes. Tighten the screws.
5.
Ensure that the other holes in the mounting brackets are aligned with the holes in the
6.
side panels. Insert a screw in each hole and tighten the screws.
Have one person grasp both sides of the switch, lift the switch, and position it in the
7.
rack, aligning the mounting bracket holes with the threaded holes in the rack rail. Align
the bottom hole in each mounting bracket with a hole in each rack rail, making sure
the chassis is level. See Figure 25 on page 124.
Chapter 11: Installing the Switch
"Unpacking an EX2200 Switch" on
123