Figure 58: Removing An Sfp, Sfp+, Xfp, Or A Qsfp+ Transceiver From A - Juniper EX2200 Hardware Manual

Copyright © 2016, Juniper Networks, Inc.
To remove an SFP, SFP+, XFP, or a QSFP+ transceiver:
4.
By using your fingers, pull open the ejector lever on the transceiver to unlock the
a.
transceiver.
CAUTION:
the ejector lever completely until you hear it click. This prevents damage
to the transceiver.
Grasp the transceiver ejector lever and gently slide the transceiver approximately
b.
0.5 in. (1.3 cm) straight out of the port.
CAUTION:
transceiver, do not touch the connector pins at the end of the
transceiver.
To remove a CFP transceiver:
Loosen the screws on the transceiver by using your fingers.
a.
Grasp the screws on the transceiver and gently slide the transceiver approximately
b.
0.5 in. (1.3 cm) straight out of the port.
CAUTION:
transceiver, do not touch the connector pins at the end of the
transceiver.

Figure 58: Removing an SFP, SFP+, XFP, or a QSFP+ Transceiver from a

Switch
1— Ejector lever
By using your fingers, grasp the body of the transceiver and pull it straight out of the
5.
port.
Place the transceiver in the antistatic bag or on the antistatic mat placed on a flat,
6.
stable surface.
Place the dust cover over the empty port.
7.
Before removing the transceiver, make sure that you open
To prevent electrostatic discharge (ESD) damage to the
To prevent electrostatic discharge (ESD) damage to the
Chapter 15: Replacing Transceiver
181