Packing A Switch For Shipping; Packing Switch Components For Shipping - Juniper EX2200 Hardware Manual

EX2200 and EX2200-C Switches Hardware Guide

Packing a Switch for Shipping

Packing Switch Components for Shipping

192
To pack a switch for shipping:
On the console or other management device connected to the switch, enter the CLI
1.
operational mode and issue the following command to shut down the switch software:
user@switch> request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
Disconnect power from the switch by performing one of the following:
2.
If the power source outlet has a power switch, set it to the OFF (0) position.
If the power source outlet does not have a power switch, gently pull out the male
end of the power cord connected to the power source outlet.
Remove the cables that connect the switch to all external devices. See
3.
a Fiber-Optic Cable from a Switch" on page
Remove all optical transceivers installed in the switch. See
4.
from a Switch" on page
If the switch is mounted on a wall or on two posts, have one person hold the switch
5.
while another person unscrews and removes the mounting screws.
Use the Phillips (+) screwdriver, number 2 to remove the screws.
6.
Remove the switch from the wall, rack, cabinet, or desk and place the switch in an
7.
antistatic bag.
Slip on the end caps of the packaging foam on both sides of the switch.
8.
Place the switch in the shipping carton.
9.
Place the packing foam on top of and around the switch.
10.
If you are returning accessories or FRUs with the switch, pack them as instructed in
11.
"Packing Switch Components for Shipping" on page
Close the top of the cardboard carton and seal it with packing tape.
12.
Write the RMA number on the exterior of the carton to ensure proper tracking.
13.
To pack and ship switch components:
Place individual components in antistatic bags.
Ensure that the components are adequately protected with packing materials and
packed so that the pieces are prevented from moving around inside the carton.
Close the top of the cardboard shipping carton and seal it with packing tape.
Write the RMA number on the exterior of the carton to ensure proper tracking.
184.
179.
"Disconnecting
"Removing a Transceiver
192.
Copyright © 2016, Juniper Networks, Inc.