Management Port Connector Pinout Information For An Ex2200 Switch; Table 43: Management Port Connector Pinout Information For Ex2200 - Juniper EX2200 Hardware Manual

EX2200 and EX2200-C Switches Hardware Guide
Related
Documentation

Management Port Connector Pinout Information for an EX2200 Switch

Table 43: Management Port Connector Pinout Information for EX2200 Switches
Pin
1
2
3
6
Related
Documentation
108
EX2200 Switches Hardware Overview on page 3
EX2300 Switches Hardware Overview
Rear Panel of an EX3200 Switch
Rear Panel of an EX3300 Switch
Rear Panel of an EX3400 Switch
Rear Panel of an EX4200 Switch
EX4300 Switches Hardware Overview
Front Panel of an EX4500 Switch
Management Panel of an EX4600 Switch
EX4550 Switches Hardware Overview
Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch
Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch
Routing Engine (RE) Module in an EX8216 Switch
Routing Engine Module in an EX9200 Switch
Booting an EX Series Switch Using a Software Package Stored on a USB Flash Drive
The management port on an EX2200 switch uses an RJ-45 connector to connect to a
management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100Base-T connection.
Two LEDs on the port indicate link/activity on the port and the administrative status of
the port. See "Management Port LEDs in EX2200 Switches" on page
Table 43 on page 108 provides the pinout information for the RJ-45 connector for the
management port. An RJ-45 cable, with a connector attached, is supplied with the switch.
Signal
TRP1+
TRP1-
TRP2+
TRP2-
See EX2200 Switches Hardware Overview on page 3
Connecting a Switch to a Network for Out-of-Band Management on page 155
15.
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 2
for port location.
Copyright © 2016, Juniper Networks, Inc.