Figure 13: Port Status Mode Leds Of The Dual-Purpose Uplink Ports Of An; Table 9: Link/Activity Led On The Network Ports And Uplink Ports In Ex2200; Table 10: Status Led On The Network Ports, Uplink Ports, And Dual-Purpose - Juniper EX2200 Hardware Manual

Table 9: Link/Activity LED on the Network Ports and Uplink Ports in EX2200 Switches
LED Color
Link/Activity Green
Table 10: Status LED on the Network Ports, Uplink Ports, and Dual-Purpose Uplink Ports in
EX2200 Switches
Port Parameters
Speed
Copyright © 2016, Juniper Networks, Inc.

Figure 13: Port Status Mode LEDs of the Dual-Purpose Uplink Ports of an

EX2200-C Switch
Table 9 on page 17 describes the Link/Activity LED.
State and Description
Blinking—The port and the link are active, and there is link activity.
On steadily—The port and the link are active, but there is no link activity.
Off—The port is not active.
In Figure 11 on page 16, Figure 12 on page
indicate the status of one of the four port parameters—speed, duplex mode, administrative
status, and Power over Ethernet (PoE) status. Use the Factory reset/Mode button below
the LED labeled POE on the far right side of the front panel to toggle the Status LED to
show the different port parameters. You can tell which port parameter is indicated by
the Status LED by looking at which port status mode LED (SPD, DX, EN, and POE) is lit.
(See Figure 12 on page 16).
Table 10 on page 17 describes the Status LED.
State and Description
Indicates the speed. The speed indicators for network ports are:
One blink per second—10 Mbps
Two blinks per second—100 Mbps
Three blinks per second—1000 Mbps
The speed indicators for uplink ports are:
On steadily—1000 Mbps
Off—10/100 Mbps
The speed indicators for dual-purpose uplink ports of EX2200-C switch model are:
One blink per second—10 Mbps
Two blinks per second—100 Mbps
Three blinks per second—1000 Mbps
Chapter 2: Chassis Components and Descriptions
16, and Figure 13 on page 17 show the LEDs that
17