Juniper EX2200 Hardware Manual page 40

EX2200 and EX2200-C Switches Hardware Guide
Table 10: Status LED on the Network Ports, Uplink Ports, and Dual-Purpose Uplink Ports in
EX2200 Switches (continued)
Port Parameters
Duplex mode
Administrative status
PoE status
Related
Documentation
18
State and Description
Indicates the duplex mode. The status indicators are:
On steadily—Port is set to full-duplex mode.
Off—Port is set to half-duplex mode.
Indicates the administrative status. The status indicators are:
On steadily—Port is administratively enabled.
Off—Port is administratively disabled.
Indicates the PoE status. The status indicators for network ports are:
On steadily—PoE is available on the port, a device that draws power from the port
is connected to the port, and the device is drawing power from the port.
Blinking—PoE is available on the port, but no power is drawn from the port because
of one of the following:
No device that draws power from the port is connected to the port.
A device that draws power from the port is connected to the port, but the device
is not drawing any power from the port.
Off—PoE is not available on the port.
NOTE: PoE Status LED is available on the following EX2200 switch models:
EX2200-C-12P
EX2200-24P
EX2200-48P
PoE is not available on uplink ports; therefore, the LED for those ports is always unlit.
You can tell which port parameter is indicated by the Status LED on network ports, uplink
ports, and dual-purpose uplink ports by issuing the operational mode command
.
chassis led
EX2200 Switches Hardware Overview on page 3
Configuring Gigabit Ethernet Interfaces (CLI Procedure)
Configuring Gigabit Ethernet Interfaces (J-Web Procedure)
Copyright © 2016, Juniper Networks, Inc.
show