Transceiver And Cable Specifications; Pluggable Transceivers Supported On Ex2200 Switches - Juniper EX2200 Hardware Manual

CHAPTER 8

Transceiver and Cable Specifications

Pluggable Transceivers Supported on EX2200 Switches

Copyright © 2016, Juniper Networks, Inc.
Pluggable Transceivers Supported on EX2200 Switches on page 69
Pluggable Transceivers Supported on EX Series Switches on page 101
Network Cable Specifications for EX2200 Switches on page 103
Understanding EX Series Switches Fiber-Optic Cable Signal Loss, Attenuation, and
Dispersion on page 103
Uplink ports and dual-purpose uplink ports on the front panel in EX2200 switches support
SFP transceivers. This topic describes the optical interfaces supported for those
transceivers. It also lists the copper interface supported for the SFP transceivers. For the
full specifications of these transceivers, see
NOTE: We recommend that you use only optical transceivers and optical
connectors purchased from Juniper Networks with your Juniper Networks
device.
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
The Hardware Compatibility Tool
.
69