Figure 61: Placing A Component Into An Antistatic Bag - Juniper EX2200 Hardware Manual

EX2200 and EX2200-C Switches Hardware Guide
Related
Documentation
246
If no grounding strap is available, touch the exposed, bare metal of the device to ground
yourself before handling the component.
Avoid contact between the component that is subject to ESD damage and your clothing.
ESD voltages emitted from clothing can damage components.
When removing or installing a component that is subject to ESD damage, always place
it component-side up on an antistatic surface, in an antistatic card rack, or in an
antistatic bag (see Figure 61 on page
an antistatic bag before packing it.

Figure 61: Placing a Component into an Antistatic Bag

CAUTION
ELECTROSTATIC
SENSITIVE
DEVICES
DO NOT OPEN OR HANDLE
EXCEPT AT A
STATIC-FREE WORKSTATION
CAUTION: ANSI/TIA/EIA-568 cables such as Category 5e and Category 6
can get electrostatically charged. To dissipate this charge, always ground
the cables to a suitable and safe earth ground before connecting them to the
system.
See General Safety Guidelines and Warnings on page
See EX2200 Switches Hardware Overview on page 3
See Rear Panel of an EX3200 Switch for the ESD point location.
See Rear Panel of an EX3300 Switch for the ESD point location.
See Rear Panel of an EX4200 Switch for the ESD point location.
See EX4300 Switches Hardware Overview for the ESD point location.
See Front Panel of an EX4500 Switch for the ESD point location.
See EX4550 Switches Hardware Overview for the ESD point location.
See Chassis Physical Specifications of an EX6210 Switch for the ESD point location.
See Chassis Physical Specifications of an EX8208 Switch for the ESD point location.
See Chassis Physical Specifications of an EX8216 Switch for the ESD point location.
See EX9204 Switch Hardware Overview for the ESD point location.
246). If you are returning a component, place it in
211.
for the ESD point location.
Copyright © 2016, Juniper Networks, Inc.