Juniper EX2200 Hardware Manual page 59

Table 21: Chassis Viewer for EX3400 and EX4300 Switches (continued)
Field Description
PIC 2 slot You can install an uplink module in the PIC 2 slot. Mouse over the ports in the module to view the
details of the ports in module.
24-port and 48-port EX4300 switches support the 4-port 10-Gigabit Ethernet SFP+ uplink module.
24-port and 48-port EX3400 switches support the 4-port 10-Gigabit Ethernet uplink ports.
EX4300-32F switches support the 2-port 40-Gigabit Ethernet uplink module and the 8-port
10-Gigabit Ethernet SFP+ uplink module.
When you install a transceiver in the port, the following colors denote the interface status:
NOTE: In EX3400 and EX4300 switches, the LEDs are seen in the front panel, these are not active.
Rear View of the EX3400 and EX4300 Switch
Management port The management port is used to connect the switch to a management device for out-of-band
management.
Console port The console port (RJ-45) is used to connect the switch to a management console or to a console
server.
USB port Indicates the USB port for the switch.
NOTE:
EX Series switch.
Fan tray Mouse over the fan tray icons to display name, status, and description information.
Power supplies Mouse over the power supply icons to display name, status, and description information.
PIC 1 slot The rear panel of a 24-port and a 48-port EX4300 switch has four (built-in) 40-Gigabit Ethernet
ports. The rear panel of a 24-port and a 48-port EX3400 switch and an EX4300-32F switch has
two (built-in) 40-Gigabit Ethernet ports, in which you can install QSFP+ transceivers. Mouse over
the ports to view the details of the ports.
After you install a transceiver in the port, the following colors denote the interface status:
For 40-Gigabit Ethernet ports, the interfaces appear dimmed if no transceiver is inserted. The chassis
viewer displays
When a 40-Gigabit Ethernet port is configured as a VCP, the following colors denote the VCP status:
Copyright © 2016, Juniper Networks, Inc.
Green—Interface is up and operational.
Yellow—Interface is up but is not operational.
Gray—Interface is down and not operational.
We recommend that you use USB flash drives purchased from Juniper Networks for your
Green—Interface is up and operational.
Yellow—Interface is up but is not operational.
Gray—Interface is down and not operational.
Transceiver not plugged in
Green—VCP is up and operational.
Yellow—VCP is up but is not operational.
Gray—VCP is down and not operational.
Chapter 5: Viewing System Information
when you mouse over the port.
37