Juniper EX2200 Hardware Manual page 200

EX2200 and EX2200-C Switches Hardware Guide
178
Before you begin installing a transceiver in an EX Series switch, ensure that you have
taken the necessary precautions for safe handling of lasers (see
Guidelines and Warnings for Switches" on page
Ensure that you have a rubber safety cap available to cover the transceiver.
Figure 57 on page 179 shows how to install a QSFP+ transceiver. The procedure is the
same for all types of transceivers except the CFP transceivers.
To install a transceiver in an EX Series switch:
CAUTION: To prevent electrostatic discharge (ESD) damage to the
transceiver, do not touch the connector pins at the end of the transceiver.
Remove the transceiver from its bag.
1.
Check to see whether the transceiver is covered with a rubber safety cap. If it is not,
2.
cover the transceiver with a rubber safety cap.
WARNING: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing a cable. The rubber safety cap keeps the port clean
and prevents accidental exposure to laser light.
If the port in which you want to install the transceiver is covered with a dust cover,
3.
remove the dust cover and save it in case you need to cover the port later. If you are
hot-swapping a transceiver, wait for at least 10 seconds after removing the transceiver
from the port before installing a new transceiver.
Using both hands, carefully place the transceiver in the empty port. The connectors
4.
must face the switch chassis.
CAUTION: Before you slide the transceiver into the port, ensure that the
transceiver is aligned correctly. Misalignment might cause the pins to
bend, making the transceiver unusable.
Slide the transceiver in gently until it is fully seated. If you are installing a CFP
5.
transceiver, tighten the captive screws on the transceiver by using your fingers.
Remove the rubber safety cap when you are ready to connect the cable to the
6.
transceiver.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.
"Laser and LED Safety
231).
Copyright © 2016, Juniper Networks, Inc.