Mounting An Ex2200-C Switch On A Wall; Figure 31: Measurements For Installing Mounting Screws; Figure 32: Mounting The Switch On A Wall - Juniper EX2200 Hardware Manual

Mounting an EX2200-C Switch on a Wall

Copyright © 2016, Juniper Networks, Inc.

Figure 31: Measurements for Installing Mounting Screws

Rear
8.32 in. (21.1 cm)
2.76 in (7 cm)
A
5.98 in.
(15.2 cm)
C
Front
Lift the unit (one switch or two) by grasping each side, and hang the unit by attaching
5.
the brackets to the mounting screws as shown in
For PoE models, install the baffle by attaching it to screws E and F.
6.
Tighten all mounting screws.
7.

Figure 32: Mounting the Switch on a Wall

Hang attached brackets
on wall-mounted screws.
You can mount an EX2200-C switch, the compact, fanless model, on a wall by using the
flexible mounting slots on the bottom of the chassis to fix to the screws on the wall.
Baffle for PoE Models
(EX2200-24P and EX2200-48P)
18.68 in. (47.4 cm)
4.49 in.
(11.4 cm)
E F
Side wall-mount brackets
Figure 32 on page
Baffle for PoE Models
Rear (EX2200-24P and EX2200-48P)
panel
Front
panel
Chapter 11: Installing the Switch
B
D
131.
131