Pinout Specifications; Console Port Connector Pinout Information For An Ex Series Switch; Table 41: Ex Series Switches Console Port Connector Pinout Information; Chapter 9 Pinout Specifications - Juniper EX2200 Hardware Manual

CHAPTER 9

Pinout Specifications

Console Port Connector Pinout Information for an EX Series Switch

Table 41: EX Series Switches Console Port Connector Pinout Information

Pin Signal
1 RTS Output
2 DTR Output
3 TxD Output
4 Signal Ground
Copyright © 2016, Juniper Networks, Inc.
Console Port Connector Pinout Information for an EX Series Switch on page 105
Mini-USB Port Specifications for an EX2200 Switch on page 106
USB Port Specifications for an EX Series Switch on page 107
Management Port Connector Pinout Information for an EX2200 Switch on page 108
Network Port Connector Pinout Information for an EX2200 Switch on page 109
RJ-45 to DB-9 Serial Port Adapter Pinout Information for a Switch on page 109
The console port on an EX Series switch is an RS-232 serial interface that uses an RJ-45
connector to connect to a console management device. The default baud rate for the
console port is 9600 baud.
Table 41 on page 105 provides the pinout information for the RJ-45 console connector.
An Ethernet cable that has an RJ-45 connector at either end and an RJ-45 to DB-9 serial
port adapter are supplied with the switch.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to an EX Series switch, use a
combination of the RJ-45 to DB-9 female adapter supplied with the switch
and a USB to DB-9 male adapter. You must provide the USB to DB-9 male
adapter.
Description
Request to send
Data terminal ready
Transmit data
Signal ground
105