Juniper EX2200 Hardware Manual page 151

Copyright © 2016, Juniper Networks, Inc.
When mounting an EX2200 switch chassis in a vertical position, orient the
front panel of the chassis downward to ensure proper airflow and meet
safety requirements in the event of a fire.
When wall mounting Power over Ethernet (PoE) models (EX2200-24P
and EX2200-48P), install the wall-mount baffle above the units to reduce
the risk of objects or substances falling into the air exhaust or power supply,
which could cause a fire.
Before mounting the switch on a wall:
Verify that the site meets the requirements described in
for EX2200 Switches" on page
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines for EX2200 Switches" on page
Ensure that you have the following parts and tools available:
2 wall-mount brackets (provided in the wall-mount kit)
1 wall-mount baffle (provided in the wall-mount kit)
12 wall-mount bracket screws (provided in the wall-mount kit)
6 mounting screws (8-32 x 1.25 in. or M4 x 30 mm) (not provided)
Hollow wall anchors rated to support up to 75 lb (34 kg) if you are not screwing the
screws directly into wall studs (not provided)
Phillips (+) screwdriver, number 2
To mount one or two switches on a wall:
Remove the switch from the shipping carton (see
1.
page 113).
Attach the wall-mount brackets to the sides of the chassis using four wall-mount
2.
bracket screws on each side, as shown in
"Site Preparation Checklist
47.
211, with particular attention
"Unpacking an EX2200 Switch" on
Figure 30 on page
Chapter 11: Installing the Switch
221.
130.
129