Figure 30: Attaching Wall-Mount Brackets To A Switch Chassis - Juniper EX2200 Hardware Manual

EX2200 and EX2200-C Switches Hardware Guide
130

Figure 30: Attaching Wall-Mount Brackets to a Switch Chassis

Rear panel
Front panel
If you are mounting two switches together, align the second switch on top of the first
3.
and attach it to the mounting brackets using two additional wall-mount bracket
screws on each side. (Figure 32 on page 131
Install four mounting screws in the wall for the wall-mount brackets (and two more
4.
for the baffle if you are installing a switch that supports PoE) as shown in
Figure 31 on page 131:
Use hollow wall anchors rated to support up to 75 lb (34 kg) if you are not inserting
the mounting screws directly into wall studs.
Turn the screws only part way in, leaving about 1/4 in. (6 mm) distance between
the head of the screw and the wall.
Install screw A.
a.
Install screw B 18.68 in. (47.4 cm) from screw A on a level line.
b.
Install screw C 5.98 in. (15.2 cm) on a plumb line down from screw A and screw D
c.
5.98 in. down from screw B.
For PoE models, install screw E 2.76 in. (7 cm) up from and 8.32 in. (21.1 cm) to the
d.
right of screw A.
For PoE models, install screw F 4.49 in. (11.4 cm) to the right of screw E.
e.
Baffle for PoE Models
(EX2200-24P and EX2200-48P)
shows two aligned switches.)
Copyright © 2016, Juniper Networks, Inc.