Juniper EX2200 Hardware Manual page 222

EX2200 and EX2200-C Switches Hardware Guide
200
Table 51: Chassis Component Alarm Conditions on EX2200
Switches (continued)
Chassis
Component Alarm Condition
Temperature Temperature is below
the low operating
temperature.
Temperature is above
the high operating
temperature.
In EX2200 switches
except EX2200-C
switches: If the
temperature reaches
the shutdown
temperature low limit
of 32° F (0° C) or high
limit of 194° F (90° C)
and the shutdown
extend time is
configured through the
CLI, an alarm is raised
before the shutdown
timer starts.
In EX2200 switches
except EX2200-C
switches: The
temperature inside the
chassis has exceeded
the red alarm limit of
158° F (70° C) or
exceeded the bad fan
red alarm limit of 140° F
(60° C) and the fan is
not spinning properly.
Alarm
Severity Remedy
Major Check the fan.
(red)
Open a support case using the Case
Manager link at
http://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and Canada)
or 1-408-745-9500 (from outside the
United States).
Major Check the fan.
(red)
Open a support case using the Case
Manager link at
http://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and Canada)
or 1-408-745-9500 (from outside the
United States).
Major Check the fan.
(red)
Open a support case using the Case
Manager link at
http://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and Canada)
or 1-408-745-9500 (from outside the
United States).
Major Check the fan.
(red)
Open a support case using the Case
Manager link at
http://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and Canada)
or 1-408-745-9500 (from outside the
United States).
Minor
(yellow)
Copyright © 2016, Juniper Networks, Inc.