Juniper EX2200 Hardware Manual page 154

EX2200 and EX2200-C Switches Hardware Guide
132
WARNING: When mounting an EX2200-C switch chassis in a vertical position,
orient the front panel of the chassis downward to ensure proper airflow and
meet safety requirements in the event of a fire.
CAUTION: Do not block the vents on the top of the EX2200-C switches. Doing
this can lead to overheating of the switch chassis.
Before mounting the switch on a wall:
Verify that the site meets the requirements described in
for EX2200 Switches" on page
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines for EX2200 Switches" on page
Ensure that you have the following parts and tools available:
3 wall mounting screws (M4 x 30mm or 8-32 x 1.25 in. Phillips pan-head machine
screws—not provided)
Phillips (+) screwdriver, number 2
1 cable guard with 3 number-8 Phillips truss-head screws to secure the cable guard to
the EX2200-C switch (optional and separately orderable)
1 standard cable lock (optional and separately orderable) to secure the switch from
theft by connecting the cable to a security slot on the switch
To mount the switch on a wall:
Remove the switch from the shipping carton (see
1.
page 113).
Drill three holes A, B, and C on the wall as shown in
2.
"Site Preparation Checklist
47.
211, with particular attention
"Unpacking an EX2200 Switch" on
Figure 33 on page
Copyright © 2016, Juniper Networks, Inc.
221.
133.