Connecting A Fiber-Optic Cable To A Switch - Juniper EX2200 Hardware Manual

EX2200 and EX2200-C Switches Hardware Guide
Related
Documentation

Connecting a Fiber-Optic Cable to a Switch

160
Stop bits—1
DCD state—Disregard
Ensure that you have the following parts and tools available:
1 mini-USB cable with Standard-A and Mini-USB Type- B (5-pin) connectors (not
provided).
To connect the switch to the console using Mini-USB Type-B console port:
Connect the Standard-A connector of the mini-USB cable to the host machine (PC
1.
or Laptop).
Connect the Mini-USB Type-B (5-pin) connector of the mini-USB cable to the Mini-USB
2.
Type-B console port (labeled
Set the Mini-USB Type-B console port as the active console port by using the command
3.
.
port-type
By default, the RJ-45 port is set as an active console port and the Mini-USB Type-B
port is the passive console port. For information about configuring the console port
type, see Configuring the Console Port Type (CLI Procedure).
Reboot the switch.
4.
Reboot the switch.
5.
Once the connection is established, you will get the control and the log messages on the
Mini-USB Type-B console port.
Configuring the Console Port Type (CLI Procedure)
Connecting a Switch to a Network for Out-of-Band Management on page 155
Console Port Connector Pinout Information for an EX Series Switch on page 105
Cables Connecting the EX6200 Switch to Management Devices
Cables Connecting the EX8200 Switch to Management Devices
EX Series, OCX1100, and QFX Series switches support optical transceivers, which are
field-replaceable units (FRUs). You can connect fiber-optic cables to these transceivers.
Before you begin connecting a fiber-optic cable to an optical transceiver installed in a
switch, ensure that you have taken the necessary precautions for safe handling of lasers
(see "Laser and LED Safety Guidelines and Warnings for Switches" on page
) on the switch.
CON
Copyright © 2016, Juniper Networks, Inc.
231).