Figure 33: Measurements For Installing Mounting Screws For The Ex2200-C - Juniper EX2200 Hardware Manual

Copyright © 2016, Juniper Networks, Inc.

Figure 33: Measurements for Installing Mounting Screws for the EX2200-C

Switch
Drill hole A and install a mounting screw.
a.
Drill hole B 9.53 in. (24.2 cm) on a level line from hole A and install a mounting
b.
screw.
Mark a point P 3.98 in. (10.13 cm) on a plumb line down from hole A.
c.
From point P 4.37 in. (11.0 cm) on a level line drill hole C and install a mounting
d.
screw.
Tighten the screws only part way in, leaving about 1/4 in. (6 mm) distance between
3.
the head of the screw and the wall.
Mount the switch on the mounting screws facing front panel downwards, and slide it
4.
downward until it locks in place as shown in
Chapter 11: Installing the Switch
Figure 34 on page 134.
133