Figure 26: Attaching The Front-Mounting Bracket To The Side Mounting-Rail; Figure 27: Attaching The Side Mounting-Rail To The Switch Chassis - Juniper EX2200 Hardware Manual

EX2200 and EX2200-C Switches Hardware Guide
126

Figure 26: Attaching the Front-Mounting Bracket to the Side Mounting-Rail

1— Side mounting-rail
Place the switch on a flat, stable surface.
3.
Align the side mounting-rails along the side panels of the switch chassis. Align the
4.
two holes in the rear of the side mounting-rails with the two holes on the rear of the
side panel.
Insert Phillips 4x6-mm flat-head mounting screws into the two aligned holes and
5.
tighten the screws. Ensure that the two holes in the rear of the side mounting-rails
are aligned with the remaining two holes in the side panel. See

Figure 27: Attaching the Side Mounting-Rail to the Switch Chassis

Insert the Phillips 4x6-mm flat-head mounting screws into the remaining two holes
6.
in the side mounting-rails and tighten the screws.
Have one person grasp both sides of the switch, lift the switch, and position it in the
7.
rack, aligning the side mounting-rail holes with the threaded holes in the front post
of the rack. Align the bottom hole in both the front-mounting brackets with a hole in
each rack rail, making sure the chassis is level. See
2— Front-mounting bracket
Figure 27 on page
Figure 28 on page
Copyright © 2016, Juniper Networks, Inc.
126.
127.