Cabinet Requirements For Ex2200 Switches; Table 33: Cabinet Requirements And Specifications For The Switch - Juniper EX2200 Hardware Manual

Related
Documentation

Cabinet Requirements for EX2200 Switches

Table 33: Cabinet Requirements and Specifications for the Switch

Cabinet
Requirement Guidelines
Cabinet size You can mount the switch in a cabinet that contains a 19-in. rack as defined in Cabinets, Racks,
Panels, and Associated Equipment (document number EIA-310–D) published by the Electronics
Industry Association (
The minimum cabinet size must be able to accommodate the maximum external dimensions of the
switch.
Cabinet clearance The outer edges of the mounting brackets extend the width of the chassis to 19 in. (48.2 cm).
The minimum total clearance inside the cabinet is 30 in. (76.2 cm) between the inside of the front
door and the inside of the rear door.
Copyright © 2016, Juniper Networks, Inc.
One pair of mounting brackets for mounting the switch on two posts of a rack is supplied
with each switch. For mounting the switch on four posts of a rack or cabinet, you can
order a four-post rack-mount kit separately.
NOTE: Mounting brackets are not supplied with EX2200-C switch; they are
separately orderable.
Chassis Physical Specifications for EX2200 Switches on page 13
Clearance Requirements for Airflow and Hardware Maintenance for EX2200 Switches
on page 58
Rack-Mounting and Cabinet-Mounting Warnings on page 224
Mounting an EX2200 Switch on Two Posts of a Rack or Cabinet on page 122
Mounting an EX2200 Switch on Four Posts of a Rack or Cabinet on page 124
Mounting an EX2200 Switch in a Recessed Position in a Rack or Cabinet on page 128
You can mount the switch in a cabinet that contains a 19-in. rack.
Cabinet requirements consist of:
Cabinet size
Clearance requirements
Cabinet airflow requirements
Table 33 on page 57 provides the cabinet requirements and specifications for the switch.
http://www.ecianow.org/standards-practices/standards/
Chapter 6: Preparation Overview
).
57