Figure 28: Mounting The Switch To The Front Posts Of A Rack; Figure 29: Sliding The Rear Mounting-Blades Into The Side Mounting-Rail - Juniper EX2200 Hardware Manual

Related
Documentation
Copyright © 2016, Juniper Networks, Inc.

Figure 28: Mounting the Switch to the Front Posts of a Rack

1— Side mounting-rail
Have a second person secure the front of the switch to the rack by using the appropriate
8.
screws for your rack.
Slide the rear mounting-blades into the side mounting-rails. See
9.

Figure 29: Sliding the Rear Mounting-Blades into the Side Mounting-Rail

1— Rear mounting-blades
2—Side mounting-rail
Attach the rear mounting-blades to the rear post by using the appropriate screws for
10.
your rack. Tighten the screws.
Ensure that the switch chassis is level by verifying that all the screws on the front of
11.
the rack are aligned with the screws at the back of the rack.
Mounting an EX2200 Switch on Two Posts of a Rack or Cabinet on page 122
Connecting Earth Ground to an EX Series Switch on page 143
Chapter 11: Installing the Switch
2— Front-mounting bracket
Figure 29 on page
3— Switch
127.
127