Juniper EX2200 Hardware Manual page 225

Copyright © 2016, Juniper Networks, Inc.
Table 51: Chassis Component Alarm Conditions on EX2200
Switches (continued)
Chassis
Component Alarm Condition
Redundant RPS is disconnected.
power
system
(RPS)
RPS fan has failed.
RPS power supply has
failed.
RPS is backing up the
switch for the first time.
Management Management Ethernet
Ethernet link is down.
interface
Chapter 18: Alarms and Syslog Messages
Alarm
Severity Remedy
Major Check the RPS connection.
(red)
Major Open a support case using the Case
(red) Manager link at
http://www.juniper.net/support/
call 1-888-314-5822 (toll-free within the
United States and Canada) or
1-408-745-9500 (from outside the
United States).
Major Open a support case using the Case
(red) Manager link at
http://www.juniper.net/support/
call 1-888-314-5822 (toll-free within the
United States and Canada) or
1-408-745-9500 (from outside the
United States).
Minor Check the reason for power supply
(yellow) failure.
Major Check whether a cable is connected
(red) to the management Ethernet
interface, or whether the cable is
defective. Replace the cable if
required.
If you are unable to resolve the
problem, open a support case using
the Case Manager link at
http://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and Canada)
or 1-408-745-9500 (from outside the
United States).
or
or
203