Front Panel Of An Ex2200 Switch; Figure 1: Front Panel Of An Ex2200 Switch With 48 Gigabit Ethernet Ports; Figure 2: Front Panel Of An Ex2200 Switch With 24 Gigabit Ethernet Ports - Juniper EX2200 Hardware Manual

EX2200 and EX2200-C Switches Hardware Guide

Front Panel of an EX2200 Switch

6
The front panel of an EX2200 switch except the EX2200-C switch models consists of
the following components:
Network ports—depending on the switch model, either of:
24 or 48 10/100/1000BASE-T Gigabit Ethernet ports, with Power over Ethernet
(PoE) not available in EX2200-24T, EX2200-24T-DC, and EX2200-48T models
24 or 48 10/100/1000BASE-T Gigabit Ethernet ports, with Power over Ethernet
(PoE) available in EX2200-24P and EX2200-48P models
4 built-in SFP uplink ports. You can use these ports to forward network traffic or
configure them into Virtual Chassis ports (VCPs) to interconnect EX2200 switches
into a Virtual Chassis.
2 chassis status LEDs
4 port status mode LEDs
Factory reset/Mode button
Figure 1 on page 6 shows the front panel of an EX2200 switch with 48 Gigabit Ethernet
ports. Figure 2 on page 6 shows the front panel of an EX2200 switch with 24 Gigabit
Ethernet ports.

Figure 1: Front Panel of an EX2200 Switch with 48 Gigabit Ethernet Ports

Figure 2: Front Panel of an EX2200 Switch with 24 Gigabit Ethernet Ports

Copyright © 2016, Juniper Networks, Inc.