Figure 52: Removing An Sfp, Sfp+, Xfp, Or A Qsfp+ Transceiver - Juniper QFX10002 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.
To remove an SFP, SFP+, XFP, or a QSFP+ transceiver:
5.
By using your fingers, pull open the ejector lever on the transceiver to unlock the
a.
transceiver.
CAUTION:
the ejector lever completely until you hear it click. This prevents damage
to the transceiver.
Grasp the transceiver ejector lever and gently slide the transceiver approximately
b.
0.5 in. (1.3 cm) straight out of the port.
CAUTION:
transceiver, do not touch the connector pins at the end of the
transceiver.

Figure 52: Removing an SFP, SFP+, XFP, or a QSFP+ Transceiver

1— Ejector lever
To remove a CFP transceiver:
Loosen the screws on the transceiver by using your fingers.
a.
Grasp the screws on the transceiver and gently slide the transceiver approximately
b.
0.5 in. (1.3 cm) straight out of the port.
CAUTION:
transceiver, do not touch the connector pins at the end of the
transceiver.
By using your fingers, grasp the body of the transceiver and pull it straight out of the
6.
port.
Before removing the transceiver, make sure that you open
To prevent electrostatic discharge (ESD) damage to the
To prevent electrostatic discharge (ESD) damage to the
Chapter 4: Maintaining Components
119