Config Wac Method - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
before it can be re-authenticated.The default value is 60 seconds.
<sec 0-300> - Enter a block time between 0 and 300 seconds.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the WAC port state:
DGS-3620-28PC:admin#config wac ports 1-8 state enable
Command: config wac ports 1-8 state enable
Success.
DGS-3620-28PC:admin#
To configure the WAC port aging time:
DGS-3620-28PC:admin#config wac ports 1-5 aging_time 200
Command: config wac ports 1-5 aging_time 200
Success.
DGS-3620-28PC:admin#
121-5

config wac method

Description
This command is used to allow specification of the RADIUS protocol used by WAC to complete
RADIUS authentication. WAC shares other RADIUS configuration with 802.1X. When using this
command to set the RADIUS protocol, users must make sure the RADIUS server added by the
config radius command supports the protocol.
Format
config wac method [local | radius]
Parameters
local - Specifies the authentication will be done via the local database.
radius - Specifies the authentication will be done via the RADIUS server.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the WAC authentication method:
1269