Error Message When Detecting Command Error - SATO GY412 Operator's Manual

Section 4: Troubleshooting

4.2 ERROR MESSAGE WHEN DETECTING COMMAND ERROR

4.2.1 Printer Motion when Detecting Command Error
When [COMMAND ERROR DISPLAY] is set to "ENABLE" in Advanced Mode, the information of a command
in which a command error was detected will be shown at the bottom of the screen, and the print operation will
be paused.
COMMAND ERROR
Caaa:<bb>:cc
This error can be cleared by pressing the ONLINE key, but the data in which an error was detected will be
dumped and print operation will not be performed.
4.2.2 Position of Error Occurrence
The location of command error is shown in "Caaa" where an error is being displayed.
The number of ESC commands from ESC+A will be shown in "aaa". Note that ESC+A is not included in the
number of ESC commands, which can be displayed up to 999. If the number of ESC commands exceeds 999,
it will be shown as "999".
Example) When a command error is detected by Horizontal Print Position <H>.
---- : [ESC]A
C001 : [ESC]V100
C002 : [ESC]H99999 ← Location of command error
C003 : [ESC]L0202
C004 : [ESC]X21,ABCDEF
C005 : [ESC]Q1
C006 : [ESC]Z
In this case, C002 is the location of error.
4.2.3 Error Command Name
Command name, in which an error was detected, will be shown in "<bb>" where an error is being displayed.
* When it is 1 byte command, it will be left aligned.
Page 4-6
GY412 Operator Manual