Table of Contents
Advertisement
T
7: HT–502 B
ABLE
ASIC
End User Password Password to access the Web Configuration Menu. This field is case sensitive
Web Port
Telnet Server
IP Address
Time Zone
Self Defined Time
Zone
Language
Device Mode
Reply to ICMP on
WAN port
WAN side
HTTP/Telnet
Access
Cloned WAN MAC
Addr
LAN Subnet Mask
LAN DHCP Base IP
DHCP IP Lease
Time
DMZ IP
Port Forwarding
Grandstream Networks, Inc.
C
S
ONFIGURATION
ETTINGS
with a maximum length of 25 characters.
By default, HTTP uses port 80. This field is for customizable web port.
Default is set to YES.
There are two modes to operate the HT–502:
DHCP mode: all the field values for the Static IP mode are not used (even
though they are still saved in the Flash memory.) The HT–502 acquires its IP
address from the first DHCP server it discovers from the LAN it is connected.
Using the PPPoE feature: set the PPPoE account settings. The HT–502 will
establish a PPPoE session if any of the PPPoE fields is set.
Static IP mode: configure the IP address, Subnet Mask, Default Router IP
address, DNS Server 1 (primary), DNS Server 2 (secondary) fields. These fields
are set to zero by default.
Controls how the date/time is displayed according to the specified time zone.
TBD
Languages supported with voice prompt
This parameter controls whether the device is working in NAT router mode or
Bridge mode. Save the setting and reboot prior to configuring HT–502 .
If set to "Yes", the HT–502 will respond to the PING command from other
computers, but it also is vulnerable to the DOS attack. Default is No.
If set to "Yes", user can access the configuration page through the WAN port,
instead of through the "PC" port. Warning: this configuration is less secure than
default option. Default is No.
Enables a specific MAC address. Set in Hex format.
Sets the LAN subnet mask. Default value is 255.255.255.0
Base IP for the LAN port which functions as a Gateway for the subnet.
Default value is 192.168.2.1.
Value is set in units of hours. Default value is 120 hrs (5 Days.) The time IP
address is assigned to the LAN clients.
Forward all WAN IP traffic to a specific IP address if no matching port is used by
HT–502 or defined in port forwarding.
Forwards a matching (TCP/UDP) port to a specific LAN IP address with a
specific (TCP/UDP) port.
HT-502 User Manual
Firmware 1.0.0.29
D
EFINITIONS
Page 17 of 31
Last Updated: 01/2007
Advertisement
Table of Contents
