Front Differential - Transaxle Lubricant - Arctic Cat 2016 Wildcat Sport Service Manual

WT037A
2. Remove the oil level stick/filler plug.
WT035A
3. Remove the drain plug from the bottom of the engine
and drain the oil into a drain pan. Account for and
discard the gasket.
! WARNING
Use extreme caution when removing the oil drain plug.
Hot oil can cause severe injury and skin burns.
WT294A
4. Using the Oil Filter Wrench and a ratchet handle (or
a socket or box-end wrench), remove the old oil fil-
ter. Account for and discard the O-ring.
NOTE: Clean up any excess oil after removing the

filter.
5. Apply oil to a new filter O-ring and check to make
sure it is positioned correctly; then install the new oil
filter. Tighten securely.
6. Install the engine drain plug with new gasket and
tighten to 20 ft-lb. Pour the specified amount of the
recommended oil in the filler hole. Install the oil
level stick/filler plug.
7. Start the engine (while the vehicle is outside on level
ground) and allow it to idle for a few minutes.
8. Turn the engine off and wait approximately one minute.
9. Unscrew the oil level stick and wipe it with a clean cloth.
10. Install the oil level stick and thread into the engine case.
 NOTE: The oil level stick should be threaded into
the case for checking the oil level.
11. Remove the oil level stick; the oil level must be
within the operating range but not exceeding the
upper mark.
WT066A
CAUTION
Do not over-fill the engine with oil. Always make sure
that the oil level is not above the upper mark.
12. Inspect the area around the drain plug and oil filter
for leaks.
Front Differential -
Transaxle Lubricant
To check front differential lubricant, use the following
procedure.
1. Remove the level plug; lubricant should be level
with the bottom threads.
WS001A
9