Table of Contents
Advertisement
Printing an Image from Data
Starting the Printing Operation
The following describes the procedures printing.
For various function settings, refer to "Chapter4 Various Setting".
• If the temperature in the water heater or in the UV irradiation device has
not reached the predetermined value, a message is indicated. In this case,
printing is disabled. It is enabled when the error indication is disappeared.
• Data can be transmitted even when either of these message are indicated.
Printing is started after the indication is disappeared.
STEPS:
1. Set the media.
2. Touch the [REMOTE]. in the LOCAL mode.
• When setting the [LAYER] by the UV
level, indicate the number of layer at
the right bottom of the remote display
to confirm the intensity of the light
level. Press the jog key [ ] or [ ] in
this mode to change a layer and that
allows the change of the UV level.
3. Transmit the data from the computer.
The printing conditions that are displayed.
For the method of data transmission, see the
manual for the output software.
< REMOTE >
UV NOT READY
< REMOTE >
WATER NOT READY
PRIORITY
- 2-30 -
< REMOTE >
< REMOTE >
The number of layer
by the UV level
Resolution: 600 DPI
< REMOTE > 600X 600
HOST / 4P
Pass
P.4-6
1
Advertisement
Table of Contents
