Table of Contents
Advertisement
4. Printing is started printing.
• The origin remain unchanged after printing.
• When printing the same data repeatedly, use
the copy function. (
• During printing, media may be heated
by the UV lamp and become raised
and it may cause printing to be inter-
rupted. In this case, set new media
and restart printing.
5. After printing, turn the vacuum switch off,
and then remove the media from the table.
[In case of Leaf Media]
Press the sub switch [VACUUM] to stop
adsorbing and remove the media.
[In case of Roll Media]
1. Select the [Roll Media Set] screen on the
touch panel.
2. Touch the [VACUUM] to stop adsorbing.
3. Touch the [FEED] to feed the media to out
of the table.
P. 2-30)
- 2-31 -
Advertisement
Table of Contents
