Registering Two Or More Printing Conditions At A Time (Selecting A Type); Changing The Type - MIMAKI UJF-605RII Operation Manual

Registering Two or More Printing Conditions at a Time (Selecting a
type)
Register a sequence of printing conditions set in the FUNCTION mode in the printer. By
allocating the sequence of printing conditions to any of [Type 1] through [Type 4], it is
possible to reuse the same printing conditions registered by type. It is, therefore, conve-
nient to allocate different printing conditions to different types according to the media and
printing method used. The procedures for allocating a specific sequence of printing condi-
tions to a type are described below. Here, the method of registration by allocating printing
conditions to a particular type is explained.
4 kind of selectable types are available. [Type1] [Type 2] [Type 3] [Type 4]
STEPS:
1. Touch the [FUNCTION] in the LOCAL
mode.
2. Touch the JOG [ ] to select the [SET UP].
3. Touch the [ENTER].
4. Select any of [Type 1] through [Type 4] by
touching the JOG[ ] or [ ].
5. Touch the [ENTER].
Now set each printing conditions.
(Refer to page 4-5)

Changing the type

If printing conditions have already been registered as [Type 1] through [Type 4], printing
conditions can be set simply by selecting a type.
1. Perform the above STEP 1 through 5.
Select a type.
2. Touch the [END].
Printing by the selected type is enabled.
- 4-4 -
FUNCTION
DATE CLEAR
FUNCTION
SET UP
SET UP
SELECT
SET UP
SELECT
TYPE3
QUALITY
SET UP
SELECT
TYPE3
QUALITY
< ENT >
< ENT >
: TYPE1
: TYEP3
< ent >
: TYPE1
< ent >