Table of Contents
Advertisement
5. Touch the JOG [ ] or [ ] to select the
resolution for the test pattern.
6. Touch the [ENTER].
7. Touch the JOG [ ] or [ ] to select the
printing quality for the test pattern.
8. Touch the [ENTER] to start the test draw-
ing.
• If the temperature in the water heater
or in the UV device has not reached
the predetermined value, a message
is indicated. In this case, printing is
disabled. It is enabled when the error
indication disappears.
∗∗∗∗∗∗∗∗
UV NOT READY
∗∗∗∗∗∗∗∗
WATER NOT READY
9. After the test drawing is completed, check
the test pattern.
If the UV lamp intensity goes lower, a good
printing pattern cannot be obtained. Go to the
following steps.
- 5-21 -
HARDEN CHK
DPI
: 600 x 600
HARDEN CHK
QUALITY
HARDEN CHK
QUALITY
: HIGHspd
∗∗TEST DRAW∗∗
: STD
Advertisement
Table of Contents
