Table of Contents
Advertisement
18. Feed the media.
Touch the [BLOW] and [FEED] on the touch panel
to feed the media.
The sub switch works the same operation.
While touching the panel, feeding keeps working.
19. Correct some winkles and bending.
If wrinkles occur on the feeding media, start from
STEP 13 again.
20. Adsorb the media to the table.
Touch the [VACUUM] to adsorb on the touch
panel with feeding stopped the media on the
table. Touch the [Roll Print].
21. Make sure of feeding the media.
While touching the [TENSION] and [LOCK] of the
touch panel, make sure of feeding media without
any wrinkles under circumstance of cycle, such as
[FEED] - [VACUUM] - [BLOW] - [FEED] and
setting media will be completed.
Media
- 2-16 -
Wrinkles
Advertisement
Table of Contents
