Setting the Printing Origin
When printing in an area not initially set, change the printing origin.
The printing origin can be set in two ways:
• Setting the printing origin using the JOG
• Setting the printing origin using [ORIGIN] setting from the [FUNCTION] menu.
Setting the printing origin using the JOG
STEPS:
1. Touch the JOG [ ], [ ], [ ] or [ ] in the
LOCAL mode to move the carriage to the
position where you set an origin.
• The corner of right front side of the carriage
is the origin.
2. After deciding the origin, touch the [EN-
TER].
• The new setting is saved until the origin or
the print area is changed.
• To precisely set the origin, use [ORIGIN] in
[FUNCTION] menu.
• Setting the origin by the JOG is cleared when
turning the printer off.
Media
Setting origin position using JOG
- 2-25 -
ORIGIN SET
500.0
600.0
Origin position
Origin position
(front and rear)
(left and right)
∗∗ ORIGIN ∗∗
Table
New origin
Initial origin