Table of Contents
Advertisement
Printing an image from source data
Starting the printing operation
The following describes the method of printing.
For various function settings necessary for printing, refer to "CHP5 Setting Function".
• If the temperature in the water heater or in the UV device has not reached
• Data can be transmitted even when both errors are indicated. Printing
STEPS:
1. Make sure to set the media and turn the
vacuum switch has been on.
2. The device enters the LOCAL mode.
3. Press the [REMOTE] key.
• Adjust the head gap when Sense
mode has been set. See the descrip-
tion of gap check (
• In other mode, gap check is per-
formed as well with the latest mode
and the head gap value in the case
the head gap mode is changed or
after turning on the main power.
• When registration mark detection has
been set, the registration marks are
detected in the same procedure as
registration mark checking. For de-
tails, see Chapter 4.
(
detection is not necessary, press the
[END] key. <REMOTE> screen is
restored.
• When setting the [LAYER] by the UV
level, indicate the number of layer at
the right bottom of the remote display
to confirm the intensity of the light
level. Press the jog key [ ] or [ ] in
this mode to change a layer and that
allows the change of the UV level.
the predetermined value, a message is indicated. In this case, printing is
disabled. It is enabled when the error indication has disappeared.
< REMOTE >
UV NOT READY
starts after the indication has disappeared.
P.2-13).
P.4-8). When registration mark
< REMOTE >
WATER NOT READY
- 2-21 -
<< LOCAL >>
< REMOTE >
** TABLE FALL**
PLEASE WAIT
MARK DETECT
*****.*
*****.*
< REMOTE >
The number of layer
by the UV level
1
Advertisement
Table of Contents
