How To Move Printer - MIMAKI UJF-605RII Operation Manual

How to Move Printer

When moving this printer, lift up the level feet and touch the 4 corners of the printer by 4
persons slowly.
• When moving the printer to the other place, contact a local representative
of MIMAKI. If you move it, failures may occur.
Be sure to entrust the specialist to move the printer.
• Be sure to disconnect the interface cable and before moving the printer.
• Before moving the unit, wait until the UV lamp is cooled.
• When moving the printer, take care not to shake it.
• Be sure to adjust the level feet so that the printer is level after moving it.
• Do not hold the table or the ink cartridges, or it may give damage to the
printer.
Raising and Lowering Level Feet
Before moving the printer, raise the level feet sufficiently so that the printer easily rolls.
When installing the printer, lower the level feet.
• This printer has eight level feet. Lower
them sequentially and slowly so that the
gaps between the casters and the floor
are nearly even.
Level foot
- 1-3 -