Setting Precisely The Origin ([Function] - [Origin]) - MIMAKI UJF-605RII Operation Manual

Setting Precisely the Origin ([FUNCTION] - [ORIGIN])

To precisely set the origin of coordinates, set its X- and Y- coordinates from the [FUNC-
TION] menu. This setting value become the origin position (0, 0).
• After setting the origin position (0, 0), it is not cleared when the power is
turned off. However, if the origin position is changed by JOG operation, the
setting value is cleared. (
STEPS:
1. Touch the [FUNCTION] in the LOCAL
mode.
2. Touch the JOG [ ] or [ ] to select [ORI-
GIN].
3. Touch the [ENTER].
4. Touch the [ENTER] again to select [X
OFFSET].
Set the X origin.
5. Touch the JOG [ ] or [ ] to enter the
setting value.
The number above the offset is indicated as the
distance from the origin to the maximum printing
width.
6. Touch the [ENTER].
Display enters the STEP 3.
P. 2-25)
Y
New origin position
20mm
X
10mm
- 2-26 -
FUNCTION
DATA CLEAR
FUNCTION
ORIGIN
ORIGIN
X OFFSET
ORIGIN ( 500mm)
X OFFSET
ORIGIN ( 490mm)
X OFFSET
ORIGIN
X OFFSET
<ENT>
<ENT>
<ent>
0mm
10mm
<ent>