Table of Contents
Advertisement
22. The roll media set is completed.
Complete the roll media setting with the roll media
cover attached.
If wrinkles and bending on the media are not solved.
The roll holder tilts against the printing panel roller.
Correct the tilt of the roll holder.
a. Loosen up the right and left two CS6x15SMW
screws located at the holder block, which fixes
the feeding unit to the printer in order to correct
the tilt of the roll holder.
b. Adjust the feeding unit up and down.
Adjust the tilt with a CS8x40 hexagon wrench.
After correcting the tilt with the screw, tighten
the right and left two CS6x15SMW which fix
the feeding unit.
• When the media size is small and
adsorption holes are free, cover them
with the same media and fix it with an
adhesive tape like a drafting tape
which does not remain any paste on
the table.
Roll media cover
Feeding unit rear side
Holder block
- 2-17 -
Printer side junction
CS6x15SMW
screws
Feeding unit
CS8x40 screw
Advertisement
Table of Contents
