Table of Contents
Advertisement
Error message
ERROR 20
I / F BOARD
ERROR 23
HOST I / F
ERROR 24
I / F INITIAL
ERROR 30
OPERATION
ERROR 34
DATA REMAIN
ERROR 40
MOTOR X
ERROR 41
MOTOR Y
ERROR 42
X CURRENT
ERROR 43
Y CURRENT
ERROR 44
SCAN RANGE
ERROR 50
X ORIGIN
ERROR 51
Y ORIGIN
ERROR 53
STEP MOTOR ORIGIN
Cause
An error occurs on the interface of
the I/F board and the control circuit
board.
A timeout error occurs during
communication between the host
computer and the interface board.
An initial operation failure of the I/F
board and the control circuit board.
A wrong operation is performed on
the touch panel.
Settings for functions is tried to be
changed though received data that
has not been printed yet remains.
The X motor has been overload.
The Y motor has been overload.
The overcurrent error on the X
motor has been detected.
The overcurrent error on the Y
motor has been detected.
Out of scanning is occurred.
The X origin could not be detected.
The Y origin could not be detected.
The step motor origin can not be
detected.
- 6-7 -
Corrective measures
Turn off the power and turn it on
after a while. If the same error
message appears again on the
LCD, contact your local distributor to
call for service.
Check that the cable is securely
connected Also, check an error
does not occur in the computer.
Turn off the power and turn it on
after a while. If the same error
message appears again on the
LCD, contact your local distributor to
call for service.
Perform a proper operation.
Print all of received data or perform
the data clear function. Then,
change the settings.
Turn off the power and turn it on
after a while. If the same error
message appears again on the
LCD, contact your local distributor to
call for service.
Advertisement
Table of Contents
