Setting Media
Types of Usable Media
Only media which meet the following conditions are available:
Width
Max. Length
Max. printing width
Thickness
Roll outside diameter
Roll weight
Roll inside diameter
• When the media size is small and adsorption holes are free, cover them on the table
and fix them by an adhesive tape so that any printing trouble does not occur.
• Tape up or paste a weak adhesive or the end of the roll media.
• The thickness of usable media is for roll film media from 0.02 to 0.2 mm,
and for leaf media with 0.02 to 2.0 mm.
• Pouched films or tube films are unusable because they cannot be ab-
sorbed to the table.
• Set the media properly not to cause any wrinkles. Otherwise, printing does
not work well.
• Do not use media larger than the table area.
Indications of the Tension Volume and the Vacuum Volume
The following describes the tension volume and the vacuum volume for OPP and PET.
Finely adjust it not to cause any wrinkles.
Media
OPP
PET
Roll Media
Max. 640mm, Min. 180mm
According to the roll length
600mm x 500mm
0.02 to 0.2mm
Ø180 mm or less
25kg or less
3 inch
Thickness (mm)
Width(mm)
0.02
600
0.03
0.06
0.025
0.05
- 2-8 -
Leaf Media
Max. 620mm, Min. 180mm
520mm
0.02 to 2.0mm
–
–
–
Tension
Vacuum
50 to 60
25
10 to 80
25 to 40
10 to 90
10 to 30
10 to 90