Printing An Image From Source Data; Setting The Plotter Operation - MIMAKI Textile Jet Tx3-1600 Operation Manual

Printing an Image from Source Data

Setting the plotter operation

This section describes the basic operation of the device.
Printing conditions can be set on the device side. In this section, however, the method of printing an
image from data that has been set on the computer side and transmitted to the device is explained.
For the method of setting printing conditions on the device side, see Chapter 4 "How to Use the
Application Functions".
STEP
1. Turning the power on.
2. Set the fabric in position. (Refer to Page 2.5)
Make sure that the device enters the LOCAL mode.
3. Press [REMOTE] key.
The device enters the REMOTE mode.
4. Receive data from the computer.
The printing conditions that have been set for the data are dis-
played.
For the method of data transmission, see the manual for the output
attached to the software.
5. During the printing.
During the printing operation, the length of the fabric plotted on is
displayed.
6. After the printing operation is completed,
press [REMOTE] key to put the device back
into the LOCAL mode.
*Information on drawing data.
<REMOTE> V360 x 360
TYPE1+
The setting value has
changed, the [+] or [ - ]mark
gives display beside of the
TYPE.
<REMOTE>
12.7 m ALL / 4P / U / 12.7m
Head to use : ALL: REAR row and FRONT row
V360 x 360
Length of fabric that has been plotted on
Dividing method : U : Unidirection, B : Bidirectionl
Passes 2P : 2pass ~ 16P : 16pass
(P:Normal speed H:High speed)
FRON: FRONT row
REAR: REAR row
- 2.48 -
<< LOCAL >>
width : 1620mm
<REMOTE> V360 x 360
TYPE1
<REMOTE> V360 x 360
ALL / 4P / U / 12.7m
<< LOCAL >>
width : 1620mm
Resolution: 360/540/720 DPI
Print mode: V... Variable
:N... Normal
0.0 m