Printing An Image From Source Data; Starting The Printing Operation; Interruption Of Printing - MIMAKI UJF-3042 MkII Series Operation Manual

Printing an image from
source data

Starting the printing operation

• If the temperature of the head has not reached the
predetermined value, a message is displayed.
Printing is not allowed in such cases. When the
display is disappeared, printing can be started.
• Data transmission is allowed even if errors are
displayed. Printing is started after the display is
disappeared.
Set the media. (
1
• When you set the FAN MODE setting (
12) to "MANUAL", press [SEL] and [FUNC1]
(VACUUM) depending on the use and vacuum
the media.
Press the
2
• The machine goes in the remote mode and data
from the computer can be received.
• The table height (including the vacuum table and
the table spacer) is displayed.
Transmit data to be drawn from the
3
computer.
• Printing conditions are displayed.
• As for the data transmission method, see the
instruction manual of the output software.
Resolution
600 /900 /1200 DPI
The length of media printed
REMOTE
600x900 VD
12p / Uni / R / MP / LT 151.5mm
PRE PRINT
0 0mm 0 0mm 40° /50°
MAPS information
Nozzle recovery information
R : Performing nozzle recovery
Scan direction
Uni:Unidirectional
Number of passes
• Use LT mode when you need more
flexibility.
• When LT mode is enabled, UV light
intensity is adjusted. Please check the
printing status.
Start printing.
4
• The printing origin is not changed after completion
of the printing.
P.2-4)
P.3-
(REMOTE) in local.
Height of the current table
POST
LT mode setting
LT : LT mode active
MP: MAPS function active
Chapter 2 Basic Operation
Taking out the media after completion of
5
printing.
(1) When you made vacuum "ON", Press the
[FUNC1] (VACUUM)
"OFF".
(Only for UJF-3042MkII EX/UJF-3042MkII
EX e, UJF-6042MkII/UJF-6042MkII e or
when using an absorption table.)
• When you use the vacuum function of
the vacuum table to draw, turn "OFF" the
vacuum when printing has been
completed.
(2) Remove the media.
• During printing, media may be heated by the LED
UV and raised, causing printing to be interrupted.
In this case, set new media and restart printing.

Interruption of printing

To interrupt printing, stop the printing operation and erase
the received data from the machine.
Press (LOCAL) while printing.
1
• Printing operation stops.
• When data is transmitted from the computer, the
computer stops transmission of data.
• To restart printing, press the [FUNC3]
(REMOTE).
Press the
2
• "DATA CLEAR" appears on the lower line of the
display.
Press (DATACLEAR).
3
Press the
4
• Received data is erased and the machine returns
to the local mode. The tabel moves to the
evacuation position.
to turn the adsorption
key onece.
key.
2-9
2
2
2
5
6