When The Waste Ink Tank Becomes Full - MIMAKI UJF-605RII Operation Manual

When the Waste Ink Tank Becomes Full

Waste ink used for cleaning the heads gathers in the waste ink tank.
• Contact your local MIMAKI distributor or call a local MIMAKI office if you
need a spare waste ink tank.
• Prepare a polyethylene tank in which to empty the waste ink.
• Ink drips during cleaning, so wait until it stops dripping.
When the waste ink tank is filled with waste ink, the following error message is indicated:
! INK TANK
WASTE TANK FULL
STEPS:
1. Open the waste ink tank cover.
2. Pull down the waste ink tank and pull it
out.
• When pulling out the waste ink tank,
pull it out slowly with paper over the
tank opening to prevent ink from
spattering.
• Before replacing the waste ink tank,
put paper on the floor to prevent it
from staining with ink.
3. Dump waste ink into another polyethylene
tank.
• Discard the waste ink by the local
regulations of the area in which this
unit is used.
4. Put the empty waste ink tank back into the
printer.
Close the Waste ink cover.
• To avoid hurt hands at the corner of
the tank cover, be careful to set the
tank.
5. Touch the [ENTER] to complete the proce-
dure.
The printer returns to the LOCAL mode.
- 3-7 -
WASTE TANK
TANK READY
<< LOCAL >>
:ent